Friday, March 15, 2013

Rear Tire Hugger Install

1.  Remove left side passenger foot peg bracket. (10mm)
2.  Loosen rear brake line bolt(12mm) and rotate the line out of the way.  Loosen the bolt only enough to rotate it or a decent amount of fluid will come out.  Tighten it  back up so it stays.
3.  Wash swing arm where the 3M outside strength double sided tape will adhere. Use alcohol and/or soap & water.
4.  Unscrew the front bolt(10mm) on the chain guard.
5.  Make sure front bolt on chain guard fits easily through bolt hole in the tire hugger.  If not roll some sand paper up and widen the hole a little.
6.  Fit tire hugger. Make sure everything lines up.
7.  Pull tire hugger off and remove backing on the 3M outside strength double sided tape.
8.  Refit the tire hugger to the previous position and press down to make the tape adhere.
9.  Screw the front bolt on the chain guard back in using the provided soft washer.
10.  Loosen the rear brake line bolt, rotate back to the original position, and tighten it back up.
11.  Reinstall left side passenger foot peg bracket.
Done!

Posted by at

3 comments:

  1. UnknownApril 9, 2013 at 6:10 PM

    That thing is pretty slick. I've seen a handful of people with them on Ninjette.org but not this many pics. Keep up the great tutorials they are lifesavers for us 250 noobs haha.

    ReplyDelete
    Replies
    1. UnknownApril 18, 2013 at 10:07 AM

      Thanks! More will come in the future, but life is getting in the way presently.

      Delete
    2. UnknownApril 24, 2013 at 12:16 PM

      Trust me I understand that. Between school and work I'm struggling to get a chance to update my blog. If you get a chance take a look: http://2wheeledlogan.blogspot.com/

      Delete

Subscribe to: Post Comments (Atom)